investigating nozzle’s orifice flow is challenging both experimentally and theoretically. this paper focuses on simulating flow inside diesel injector nozzle via ansys fluent v15. validation is performed with experimental results from winkhofler et al (2001). several important parameters such as mass flow rate, velocity profiles and pressure profiles are used for this validation. results includ...

Over the last ten years, robustness of schemes has raised an increasing interest among the CFD community. The objective of this article is to solve the quasi-one-dimensional compressible flow inside a “Shubin nozzle” and to investigate Bean-Warming and flux vector splitting methods for numerical solution of compressible flows. Two different conditions have been considered: first, there is a sup...

This paper presents the analysis of a two phase flow ejector for the transcritical CO2 cycle. A detailed simulation model of a two phase flow ejector was developed. A controllable ejector expansion device was designed, constructed, and installed in a transcritical CO2 experimental air conditioning system. System-level experimental results were obtained at different operation conditions and vari...

In this paper we prove existence, uniqueness and regularity of certain perturbed (subsonic–supersonic) transonic potential flows in a two-dimensional Riemannian manifold with “convergent–divergent” metric, which is an approximate model of the de Laval nozzle in aerodynamics. The result indicates that transonic flows obtained by quasi-one-dimensional flow model in fluid dynamics are stable with ...

over the last ten years, robustness of schemes has raised an increasing interest among the cfd community. the objective of this article is to solve the quasi-one-dimensional compressible flow inside a “shubin nozzle” and to investigate bean-warming and flux vector splitting methods for numerical solution of compressible flows. two different conditions have been considered: first, there is a sup...

A full scale physical model of a thin slab caster with a four-hole design submerged entry nozzle (SEN) was constructed. On the basis of the dimensionless Reynolds and Froude similitude criteria, the fluid flow in a full-scale model is similar to that of the actual system and, hence, the data obtained from the water model can be applied to the actual system. In order to determine the optimum ope...

a full scale physical model of a thin slab caster with a four-hole design submerged entry nozzle (sen) was constructed. on the basis of the dimensionless reynolds and froude similitude criteria, the fluid flow in a full-scale model is similar to that of the actual system and, hence, the data obtained from the water model can be applied to the actual system. in order to determine the optimum ope...

Supersonic retropropulsion provides an option that can potentially enhance drag characteristics of high mass entry, descent, and landing systems. Preliminary flow field and vehicle aerodynamic characteristics have been found in wind tunnel experiments; however, these only cover specific vehicle configurations and freestream conditions. In order to generate useful aerodynamic data that can be us...

In this paper, we construct various special solutions on a convergent-divergent surface for the steady compressible complete Euler system and established the stability of the purely subsonic flows. For a given pressure p0 prescribed at the “entry” of the surface, as the pressure p1 at the “exit” decreases, the flow patterns on the surface change continuously as those happen in a de Laval nozzle...

Nozzle clogging is a serious productivity and quality problem in continuous casting. This work reviews the causes, effects, and solutions to clogging in continuous casting nozzles. The results of a one-dimensional, steady state analysis of the heat loss from the molten steel stream through the nozzle wall are discussed. The analyses show that steel may freeze within the clog matrix for a relati...